The LCR electronic component tester allows you to test various electronic components. The device can test: diodes, coils, resistors, capacitors, and triacs. It also detects NPN and PNP transistors, N-channel and P-channel MOSFETs, JFETs, and measures their basic parameters. Thanks to the 160x128 LCD TFT display, the user receives information about the component being measured in graphical form. The screen is backlit and very legible. The T7 tester also features: a built-in battery that can be charged using a charger, a power bank, or a computer's USB port. Built-in tester - IR decoder (for infrared remote controls). Operating the meter comes down to placing the component in the ZIF test socket and pressing the button. You can also use the leads included in the set. If a component is damaged, the meter will display an appropriate message.
- model: LCR-T7
- ZIF14 socket
- 160x128 color LCD TFT display
- one-button testing
- can test: resistors, capacitors, coils, triacs, and NPN, PNP, N-channel and P-channel transistors
- can test Zener diodes
- IR remote control tester
- micro USB connector for charging
- charge indicator - LED
- Zener diode test
- automatic calibration
- automatic shutdown
- English-language interface
- built-in Li-Ion battery
- LED testing (does not apply to high-power LEDs)
- resistor measurement up to 50MΩ
- capacitor measurement up to 100mF
- ESR measurement for capacitors above 2uF
- micro USB-B connector for charging the tester
Measurement instructions using the LCR-T7 tester:
- Place the component in the ZIF socket, positioned according to the type of component being tested.
K- cathode A-Anode (LEDs)!
Connect Zener diodes with reversed polarity!
with the assigned digits 1, 2, 3 (remaining components). - Close the socket using the lever. Make sure all the leads are positioned correctly and have proper contact with the connector.
- Briefly press the TEST button. The screen will show that a test is in progress. Information about the component's parameters and type will then be displayed.
IMPORTANT! Capacitors must be discharged before testing! This also applies to new capacitors. Failure to discharge them may result in irreversible damage to the device.
The HamRadioShop kit includes:
- LCR-T7 electronic component tester
- measuring leads
- calibration jumper
- USB charging cable
